Search for: All records

The January 1st, 2024, moment magnitude (Mw) 7.5 Noto Peninsula earthquake ruptured in complex ways, challenging timely analysis of the tsunami generation. We present rapid and accurate tsunami models informed by a 6-subevent centroid moment tensor (CMT) model that we obtain by inverting teleseismic and strong motion data and validation against geodetic observations. We identify two distinct bilateral rupture episodes, including six subevents and a re-nucleation episode at its hypocenter 20 seconds after its initiation, likely aided by fault weakening. We construct a complex uplift model that aligns with known fault system geometries and is critical in modeling the observed tsunami. Our tsunami simulation can explain wave amplitude, timing, and polarity of the leading wave, which are crucial for tsunami early warning. Analyzing a 2000 multi-CMT solution ensemble and comparing to alternative rapid source models, we highlight the importance of incorporating complex source effects for realistic tsunami simulations. 

Tsunami wave observations far from the coast remain challenging due tothe logistics and cost of deploying and operating offshoreinstrumentation on a long-term basis with sufficient spatial coverageand density. Distributed Acoustic Sensing (DAS) on submarine fiber opticcables now enables real-time seafloor strain observations over distancesexceeding 100 km at a relatively low cost. Here, we evaluate thepotential contribution of DAS to tsunami warning by assessingtheoretically the sensitivity required by a DAS instrument to recordtsunami waves. Our analysis includes signals due to two effects induced by thehydrostatic pressure perturbations arising from tsunami waves: thePoisson’s effect of the submarine cable and the compliance effect of theseafloor. It also includes the effect of seafloor shear stresses andtemperature transients induced by the horizontal fluid flow associatedwith tsunami waves. The analysis is supported by fully coupled 3-Dphysics-based simulations of earthquake rupture, seismo-acoustic wavesand tsunami wave propagation. The strains from seismo-acoustic waves andstatic deformation near the earthquake source are orders of magnitudelarger than the tsunami strain signal. We illustrate a data processingprocedure to discern the tsunami signal. With enhanced low-frequencysensitivity on DAS interrogators (strain sensitivity ≈2×10 at mHz frequencies), we find that, on seafloorcables located above or near the earthquake source area, tsunamis areexpected to be observable with a sufficient signal-to-noise ratio withina few minutes of the earthquake onset. These encouraging results pavethe way towards faster tsunami warning enabled by seafloor DAS. 

Abstract. Tsunamigenic earthquakes pose considerable risks, both economically and socially, yet earthquake and tsunami hazard assessments are typically conducted separately. Earthquakes associated with unexpected tsunamis, such as the 2018 Mw  7.5 strike-slip Sulawesi earthquake, emphasize the need to study the tsunami potential of active submarine faults in different tectonic settings. Here, we investigate physics-based scenarios combining simulations of 3D earthquake dynamic rupture and seismic wave propagation with tsunami generation and propagation. We present time-dependent modeling of one-way linked and 3D fully coupled earthquakes and tsunamis for the ∼ 100 km long Húsavík–Flatey Fault Zone (HFFZ) in North Iceland. Our analysis shows that the HFFZ has the potential to generate sizable tsunamis. The six dynamic rupture models sourcing our tsunami scenarios vary regarding hypocenter location, spatiotemporal evolution, fault slip, and fault structure complexity but coincide with historical earthquake magnitudes. Earthquake dynamic rupture scenarios on a less segmented fault system, particularly with a hypocenter location in the eastern part of the fault system, have a larger potential for local tsunami generation. Here, dynamically evolving large shallow fault slip (∼ 8 m), near-surface rake rotation (± 20∘), and significant coseismic vertical displacements of the local bathymetry (± 1 m) facilitate strike-slip faulting tsunami generation. We model tsunami crest to trough differences (total wave heights) of up to ∼ 0.9 m near the town Ólafsfjörður. In contrast, none of our scenarios endanger the town of Akureyri, which is shielded by multiple reflections within the narrow Eyjafjörður bay and by Hrísey island. We compare the modeled one-way linked tsunami waveforms with simulation results using a 3D fully coupled approach. We find good agreement in the tsunami arrival times and location of maximum tsunami heights. While seismic waves result in transient motions of the sea surface and affect the ocean response, they do not appear to contribute to tsunami generation. However, complex source effects arise in the fully coupled simulations, such as tsunami dispersion effects and the complex superposition of seismic and acoustic waves within the shallow continental shelf of North Iceland. We find that the vertical velocity amplitudes of near-source acoustic waves are unexpectedly high – larger than those corresponding to the actual tsunami – which may serve as a rapid indicator of surface dynamic rupture. Our results have important implications for understanding the tsunamigenic potential of strike-slip fault systems worldwide and the coseismic acoustic wave excitation during tsunami generation and may help to inform future tsunami early warning systems. 

Abstract The 1 January 2024, moment magnitude 7.5 Noto Peninsula earthquake ruptured in complex ways, challenging analysis of its tsunami generation. We present tsunami models informed by a 6‐subevent centroid moment tensor (CMT) model obtained through Bayesian inversion of teleseismic and strong motion data. We identify two distinct bilateral rupture episodes. Initial, onshore rupture toward the southwest is followed by delayed re‐nucleation at the hypocenter, likely aided by fault weakening, causing significant seafloor uplift to the northeast. We construct a complex multi‐fault uplift model, validated against geodetic observations, that aligns with known fault system geometries and is critical in modeling the observed tsunami. The simulations can explain tsunami wave amplitude, timing, and polarity of the leading wave, which are crucial for tsunami early warning. Upon comparison with alternative source models and analysis of 2000 multi‐CMT ensemble solutions, we highlight the importance of incorporating complex source effects for realistic tsunami simulations.